ADAC Ultra PCI Raid AMI 428 Series Controller Card For Use With SCSI Devices Particularly RAID Device. Limited Quantity Available!
Specifications:
Part Number: 6000676 11500971 11500973
Please Note: This Model Does Not Come With The Memory Chip Shown On The Picture.
Download Drivers Here
Card Size | 12.3" x 4.2" (full length PCI) |
Processor | Intel i960CA; 32-bit RISC processor @ 33 MHz |
Bus Type | PCI 2.1 |
PCI Controller | Custom ASIC |
Bus Data Transfer Rate | Up to 132 MBs |
BIOS | AMIBIOS ADAC BIOS |
Cache Configuration | 4, 8, 16, 32, 64, or 128 MB through two banks using 70 ns נ36 (72-pin) SIMMs |
Firmware | 256 KB נ8 flash ROM |
Nonvolatile RAM | 8 KB נ8 for storing RAID configuration |
Operating Voltage | 5.00 V ? 0.25 V |
SCSI Controller | Up to 3 NCR 53C720s for Fast and Wide SCSI support. Up to 3 Symbios Logic 53C770 controllers are used in ADAC Ultra. |
SCSI Data Transfer Rate | Up to 20 MBs per channel for ADAC. Up to 40 MBs for ADAC Ultra. |
SCSI Bus | Single-ended |
SCSI Termination | Active |
Termination Disable | Automatic through cable detection |
Devices per SCSI Channel | Up to 15 wide or seven non-wide SCSI devices |
SCSI Device Types Supported | Synchronous or Asynchronous. See Appendix B for a list of supported SCSI devices. |
SCSI Channels | Two or three |
RAID Levels Supported | 0, 1, 3, 5,10, 30, and 50 |
SCSI Connectors | Two or three 68-pin internal high-density connectors for 16-bit SCSI devices. Two or three 50-pin internal header connectors for 8-bit SCSI devices. Two or three ultra-high density 68-pin external connector for fast and wide SCSI. |
Multiple Cards | Up to four ADAC Controllers per system |
Serial Port | 9-pin RS232C-compatible berg |